Hope this helps.
Futaba 2008SB Receiver. T16s7 Trainsmitter.
Pixhawk 2.4.8 two different units,
When the arming switched is pressed on the platform,
The throttle channel 3 +5 VDC goes to zero.
Reprogrammed the setup for channel 8 to be the throttle,
Same thing. This is why the ESC cal does not come online.
No DC voltage to the ESC.
Channel 3 from the receiver connected to the ESC
All works. Searching for the solution.
Anybody have a solutiion?
Replies