Hi all,
I went to test my drone with pixhawk 4 in position mode and it acted strangely. It works perfectly fine in manual mode but when i switch to position mode, the drone starts twitching in all directions and oscillates, eventually spins out of control. If anybody knows how to fix this please help!! Thank You!
Here's my setup:
Frame: Storm Anti-gravity 640mm
Motor: T-motor 380KV
ESC: Hobbywing 40A
FCU: Pixhawk 4 + GPS
Telemetry: RFD 868x
Battery: 6s 4000mah
TX/RX : Futaba T14SG
Flight review from PX4 io:
I started off with manual and then switched to position (green portion). You can see that the thrust goes up and down which was what i observed during flight where the drone went up and down. I did not touch my transmitter controls at all.
Replies