Hi,
Just installed new AC 3.2.2 firmware with APM Planner 2.0. Perhaps something went wrong with the installation cause PH doesn't react normally: When I connect the USB no sounds from the piezo (just short 1ms silent knock sound). Safety button is flashing. PWR green, FMU green, B/E amber, ACT flasing blue. APM Planner 2.0 or Q-Groundcontrol doesn't recognize the PH.
Any ideas to "force reboot/reset" the pixhawk or something? Is there any CLI software on MAC to inspect the Pixhawk or to give some initialize commands?
Replies