Discussions

Posted by Xaled on October 27, 2019 at 5:32am

Hi everyone, I hope this is the right place to ask this question

In my pixhawk an issue happened suddenly , I can't connect it to my PC

( the middle flash stay steady which indicate some I/O problems as I understand )

I checked the voltage regulator and I noticed that the output is 4.7 volt

also I checked the I2C (Vcc and GND) and it gives 4.7 volt also

I think the voltage regulator has broken, does that relate to the usb connection ? or I must check something else ??

I fear that something else has an issue and it destroyed the regulator ??

Any ideas ??

Thank you very much

You need to be a member of diydrones to add comments!

Email me when people reply –

Xaled October 30, 2019 at 6:52am

After re checking the regulator voltage it seems that I read the output wrong , so regulator is fine , but I still can't connect my pix to the computer.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.