Discussions

Posted by Ziga Krzicnik on September 1, 2017 at 9:37am

Hello guys

Im kinda new to that autopilot stuff so i dont rlly understand how to wire pixhawk and power it over the servo rail. Im posting a picture.

Im goona plug from 1-4 like it is shown in the picture and gonna use 3s lipo with ESC 5v and 2A.

Am i doing it right? will i fry the pixhawk?

I would be very happy for some simple expalnations, thank you very much

You need to be a member of diydrones to add comments!

Email me when people reply –

Ziga Krzicnik September 4, 2017 at 1:13am

can anyone help pls?
Ziga Krzicnik September 1, 2017 at 11:06am

I would like to power pixhawk over servo rail, cuz i dont have power module yet. But i heard many versions of how to do it: that u power from esc or bec with 5v @2A but u need remove signal? Or that i remove + wire from servo connector(middle wire of 3). Im also using the zener diode. 1 is ele 2 ail 3 is the wire from esc 4 is rudder. So if i plug like on the picture it should work cool, i plugged my sat reciver on main board.

Thank for your time

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.