Discussions

Posted by Derek Somerville on April 9, 2014 at 1:36pm

Hi there

So my port for putting the Safety Switch in to has broken away from the circuit board!!!

Help anyone, Any suggestions to fix, get flying again...

Also on a side not, it has been frying the power module to pixhawk wires.

That was on my hexa i have since rebuilt it as an f450, but not tested it yet

Thanks in advance

You need to be a member of diydrones to add comments!

Email me when people reply –

Kevin W January 7, 2015 at 8:39pm

Did you figure out an alternate way to do the switch? Mine broke away from the circuit board as well, because, well, those pixhawk cables are a pain in the ass.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.