Hi all
I am pretty new to the Pixhawk but i take the chance and bought a complete set from 3DRobotics.
The point is that i have a Futaba FX40 (MZ18) and a R6308STB receiver and using the S-Bus.
Problem:
1.When i move one of the stick, the servo chop very mutch
2. Another problem is that the collective and rudder have changes places.
This setup i hope to use in a Robbe Arcus Sport Plane.
Are there any of you that experienced the same?
Regards Per Kristian
Replies
Hi all
It seem like i can answer the question my selves.
The R6308STB haws the opportunity to run "Telemetry ON/OFF and High speed normal/high speed.
Things normalized when i put the receiver in "high speed and telemetry off.
Still it is a little bit choppy, but that could be just the refresh rate in the computer.
Regards
Per Kristian