Discussions

Please Advise !

Posted by Jeff Treadway on March 28, 2015 at 7:53am

Last night I connected my iris+ to Mission Planner on my computer. I did the initial setup wizard and installed latest firmware(I think) and set some parameters as I wanted. Geo fence-RTL-battery warning.

This morning I go to connect to make sure it's as I intended. Will not connect. I rebooted-still won't connect. I uninstalled Mission Planner on my computer-then reinstalled- still won't connect.

Should I do the wizard again-or should I have not done it the first time ? Have I somehow messed anything up in my iris+ ?

Afraid to fly until I get some advice.

Thank you,

Jeff

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • Jeff Treadway March 28, 2015 at 12:03pm
    Thanks I sent them an email this morning.
  • Admin
    Thomas J Coyle III March 28, 2015 at 11:53am

    @Jeff,

    You might want to open a trouble ticket at help@3drobotics.com if you continue to have trouble with your IRIS+ and cannot resolve it here on DIY Drones.

    Regards,

    TCIII AVD

This reply was deleted.

Activity