Hello,
I am trying to assemble power Distribution board and i have searched on Wiki site. I also found manual for the power distribution assembly. However, there is old version of the power distribution board in the manual. Can anyone tell me how to solder all those wires. I have attached pictures of what i have so far. I am not sure where to connect other cables. It would be so much helpful. Thank you so much for your time.
Replies
if on the image are all the cables displayed that came whit the board.. this is what i think you need to do.
Solder the connector whit the black and red wire to 1 of the 4 S+- places (red = + , black = - )
the other cable is for the signal to the APM you need to solder the 4 cables to the 4 S connections. You need to take care of the order these wires are solderd because this determents whitch motor go's where.
hope this helps