Hi I have managed most of my basic setup via tethered usb. I have unplugged usb and attempted to power by usb robotics adapter board does not power up...
As a nube to the apm 2.6 board am i doing anything wrong?
I notice (jumper 1) has no pins in situ... do I need to construct apply a jumper on here?
note I have not powered the tethered usb and battery at same time so board is not fried!
I have a power distribution 6 lead 3d robotics type but no power when I connect apm 2.6 to battery.
any help welcome.
not board is not armed.... but i don't get any power to arducopter 2.6 other than direct tethered connection.
how do i fault find or rectify?
Replies
Oh well not many replies on here again sussed through trial and error that the power supply board sent with my arducopter was just a sensor no (bec).........
image below
So question remains how do I power my apm 2.6 board with existing esc? I presume I need to add a jumper to to jumper 1?