Discussions

problem with arduimu v2

Posted by Ahmad Masalha on October 22, 2010 at 8:36am

hii

i'm still have the same problem with my arduimu v2 ,, the blue led didn't flash and didn't locked although  i conect it with ublox ..

some one can help me to find the problem ??

and how i can to verify my ublox configuration ??because i buy it from spark fun before some days or if some one can send me a link for ublox configuration tutorial ...

thankss 

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • SciFly October 24, 2010 at 11:23am
    Ucenter requires many binary messages to be enabled in order to display all of the information in the display- some of which are turned off when following the manual as they are not needed by Ardupilot. More info about your situation is more helpful than complaints of non functionality. For example, are you outside?Have you searched and explored the forums for answers?Odds are someone else has been there and done that. If your search turns up nothing then try to be more descriptive about youre problem and include info such as which code or hardware or firmware version you are using for the board and the GPS, etc.
    Perservearance will pay off, I promise you that.
    Good luck!
  • 3D Robotics
    Chris Anderson October 22, 2010 at 8:59am
    This is all in the manual. If you just read it before asking questions, you can save us all a lot of time.
This reply was deleted.

Activity