Discussions

PX4 Flow Windows Drivers

Posted by Rick Huebner on January 20, 2015 at 12:34pm

I have been trying to install windows drivers for the PX4Flow. I have followed the page https://pixhawk.org/users/px4flow_windows_driver and everything looks just as described, and drivers are from 5/19/2014, but when it loads the drivers, Windows 7 says "This device cannot start. (Code 10)" and it defaults back to the driver from 4/11/2013. I have also tried the install utilities from the downloads page referenced in the above referenced page, to no avail. Anyone else have this issue? This PX4Flow is hard to get working.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • moypray September 23, 2015 at 6:08pm

    Do you solve this problem?? I met the same issue and do not know how to do next. I am new here.

    Thanks.

    • Rick Huebner > moypray September 24, 2015 at 9:59pm
      I stopped trying to use it this way. The device doesn't work with apm anyway unless you also get the laser range finder, which I haven't gotten yet.
      • moypray > Rick Huebner September 25, 2015 at 4:03am

        Just connect UART 5 direct to PC and with a power supply?

      • moypray > Rick Huebner September 25, 2015 at 3:56am

        How do you use it now?

        • Rick Huebner > moypray September 25, 2015 at 6:12am
          I don't use the px4flow at all now. With the new ac3.3 firmware, it won't work at all unless it has the laser range finder, and I haven't bought one. I think it would all work fine if I did.
This reply was deleted.

Activity