Hi to all

I have just bought a PX4 Flow module with sonar sensor and connected to my Pixhawk board using the i2c cable. I've followed the instructions in this wiki page.

Actually I can't see any data from the OF, neither in the telemetry nor in the log file (I set the log bitmask as LOG_BITMASK = 131071). The Sonar too seems not to work. I tried to enable it from the "initial settings" but still have no response. Of course the board is ON and I updated its firmware using QGroundControl.

Have anyone faced the same issue? Thanks

Views: 390

Reply to This

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service