Hi, i have my first drone project to build from parts that were given to me from a friend.. and some parts that i bought by myself.
Long story short i have this parts for my drone:
1 DJI F450 Flamewheel
4 DJI 2212 / 920KV brushless motors
4 ESC Mark II / E300
1 Flysky FS-IA10B (With controller)
1 Omnibus F4 V2.1 (which does not have the XT60 connections i've seen on some videos)
Reading about it, i discovered that i might need a PDB to connect the battery to it so i can power my FC and the ESC, but then i read that the DJI F450 frame has a built-in PDB cause it has the ESC soldered to it and has a XT60 connector ready for the battery.
Then reading some more.. i read about BEC which needs to be connected to the ESC in order to not get break something when i connect the battery.
So please, diy drone gods, guide me in what i need to do next.
Adding some photos of everything.
Replies