So I finally got my radios working. When I power up with OSD plugged in radio stays solid red. If I unplug OSD then power up radios connect with each other, then I can plug in OSD and all works. OSD plug I'm talking about is the end that Ys off radio into telem . Any thoughts?
You need to be a member of diydrones to add comments!
Replies
Thanks Marcin. Don't know if I can take a clear enough picture. I got a new cable from 3DR because they said my first one was wrong.
telem port radio OSD
red 5v 5v
blk rx rx
blk tx
blk cts grd
blk grd blk
I can try to take a picture later . The copter is Hexa pre built from Udrones with all the bells and whistles. hopefully this helps.
first cable I had was:
red 5v 5v
blk rx rx
blk tx
blk cts
blk grd grd
Show us your setup.