Discussions

Posted by Derin Hakan Karakurt on May 9, 2012 at 9:10am

Hi.

In wiki, it is said that we have to calibrate rc inputs first, then load a configuration file if there is one for our plane.

When we load configuration file, RC calibration is gone, isn't it?

So should we calibrate RC again after loading PID file?

Thank you.

You need to be a member of diydrones to add comments!

calibration, configuration, file, pid, rc

Email me when people reply –

Developer

Michael Oborne May 10, 2012 at 5:48pm

im not sure i follow, its the first screen inside the config screen when you are connected to the MAV.

This reply was deleted.

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Please check your browser settings or contact your system administrator.