Hi, got my first Arducopter setup on my worktable, and got most of it figured.
But i wanted to use the integrated voltage and current measurement, and was missing the resistor for this.
So my question is if this is the same resistor that is described in the guide?
(sorry for somewhat poor english, but im from norway so :p )
3W 3.9 kohm resistor
You need to be a member of diydrones to add comments!
Replies
Hello Jan,
Please send me your postal address via email and I will send you 4 of these resistors for the APM which are shown in this link secound picture down in the red box.
My email address is martin@buildyourowndrone.co.uk
Regards
Martin.
www.buildyourowndrone.co.uk