Discussions

Spektrum Satellit

Posted by druckgott on September 24, 2011 at 11:28am

Hallo, I read this blog:

http://diydrones.com/profiles/blog/show?id=705844%3ABlogPost%3A578858&xg_source=activity&page=1#comments

Now I have buy this adapter.

I have created a hex file from the spektrum_to_ppm_encoder and upload it to the 328p chip.

I also Upload spektrum_sat_bind.pde to the atmega 1280 board.

I have connectet the Adapter and the Satelit like the picture, connectet atmega Pilot via FTDI Cabe

and have a 4.8V akku to power the unit.

But If I go on serial it says:

Spektrum Satellite binding test.
Timeout.

Do I have to connect it by a differnt way??

I do not understand it exacly.

You need to be a member of diydrones to add comments!

Email me when people reply –

Replies

druckgott September 24, 2011 at 2:06pm

Ok now I get it working.

Here is the Hexfile for the Atmega328p as attachment

For Binding the Satelit (1 Step) you have to connect it like in the picture:

And Upload this Sketch to the Atemga 1280 Board:

https://gist.github.com/ef01907a5c90dd66f987

spektrum_to_ppm_encoder.hex
druckgott September 24, 2011 at 12:00pm

Ok I can get it working to bind the satelit.

But the blue light of the board do not light up after uploading the hex file wia Bootloader.

My radio do also not work? Why?

thx

druckgott

This reply was deleted.

Activity

Neville Rodrigues liked Neville Rodrigues's profile

Santiago Perez liked Santiago Perez's profile

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.