Must say I have reecently started learning about drone building. So far I have asembled Nexacopter.
Right now I have Emax 2212/980kv motors + 30a simonk ESc
Basic setup. I was carefully folowing these instructions from this video,
https://www.youtube.com/watch?v=a0r3QpI165g
Everything was done as shown there, but somehow when I tried to upload skech via Arduino. I receive this error message. in orange field ''
'StructLocation' does not name a type
exit status 1
'StructLocation' does not name a type
Also marked in a pink is a section of code
// amatthews - USERHOOKS
#ifdef USERHOOK_FASLOOP
USERHOOK_FASTLOOP
#endif
Did anyone had the same issue? Or what could be the issue and what can be done? Mightbe someone have a code which could be suitable for me?
Kind regards Aleks
Replies