Is the a way to see that sonars, connected to a Pixhawk, are working?
I have been through all parameters in "Status" without success.
Thanks
Anders
You need to be a member of diydrones to add comments!
This reply was deleted.
Is the a way to see that sonars, connected to a Pixhawk, are working?
I have been through all parameters in "Status" without success.
Thanks
Anders
You need to be a member of diydrones to add comments!
Replies
If they're not showing up as in the status readings (I think they're called "sonarrange" or something like that, they haven't been enabled properly. Make sure that you've selected the right type of sonar and wired them up right. You might need to power cycle the Pixhawk to get any new settings to register at startup
Just to be clear, are you using Mission Planner or APM Planner?
-c