Hi I'm about to buy a RFD900 but it only comes separately where as the 915mHz module for telem data comes with the Ground Station USB both together. So which Ground Station module goes with this? Do I just use the 915 GS USB module?
Giddy everyone, I heard it was possible to save an APM settings on mission planner so that it's possible to use them again on another APM or maybe a pix hawk? Even just to back up the data settings, in case you need to reset for some reason. Please c
I heard it was possible to save F/C settings on Mission Planner so if I reset or want to make a copy onto a new APM I don't lose everything already set on that flight control unit. Thanks.
I have been working on my XUAV-Talon for a few months now and I'm totally at a loss as to why my servo's are not working correctly with the APM. I have set it up with Vtail mixing on the controller and everything is working-Ailerons are moving for ro
I have read a lot of instructions and watched so many how to videos on this subject but I am still unsure that I have it right. I have spent all my savings on his project and if I make a mistake I'm out of the game as far as my XUAV talon is concerne
I have read a lot of instructions and watched so many how to videos on this subject but I am still unsure that I have it right. I have spent all my savings on his project and if I make a mistake I'm out of the game as far as my XUAV talon is concerne
hi everyone, pretty new to building electronics but I'm building a Talon XUAV with APM 2.6. I have an 1150 Kv motor, a 70A SBEC and four servo's to connect to my APM and a Futaba R3008SB Rx. If I connect my SBEC to my APM then to my 1150Kv motor this
Hi,I have just bought an APM 2.6 and use Futaba T10J radio, so I also bought a R3008SB Rx. I have read a lot about problems with the PixHawk and Futaba Systems. Is the APM 2.6 compatible with the R3008SB Rx? Do I need to purchase a PPM converter?Than