Gender
Male
About
Location
La Spezia
About Me:
Electronics & Software Development for Unmanned Vehicles
Please tell us a bit about your UAV interest
Professional and amateur interest in UAV electronics and software design and implementation.
Activity Feed
"What do you mean?"
"I think that you have to go a little deeper investigating why you cannot see data coming back using an hardware loopback... without this working there's no chance the full system will work.
Regardi settings: I will do a capture of the registers…"
Regardi settings: I will do a capture of the registers…"
"Looks like a pretty nice antenna switch ... looks like it has no filters between antenna and modem but since it's not RSSI driven I think this should not be a critical point... "
"Hi everyone please note that escape codes lire +++ are not peculiar of Microhard units but it is common to every AT modem (99% of modem units on the market ) such codes are commobly rejected after a certain delay from powerup . Besides that you're…"
"Hallo ... this may depend upon several details:
0) which i/f board you are using to connect pixhawk to n920 unit? What bout GCS?
1) hardware connection
2) logic levels,
3) settings of the serial ports of both n920 units and pixhawk/gcs as also n920…"
0) which i/f board you are using to connect pixhawk to n920 unit? What bout GCS?
1) hardware connection
2) logic levels,
3) settings of the serial ports of both n920 units and pixhawk/gcs as also n920…"
"Hi Nicolas... please feel free to ask. My email is weirdgyn@gmail.com"
"Hallo Jaron,1) I'm using the same switching regulator Microhard uses on their boards.The Vin range it's 9-36 volts (or maybe 9-18volts) so you can provide asupply by battery or other non regulated sources.2) trough-hole connectors (1.27 or 2.54mm…"
"Hallo Jaron,
the board I designed has been manifactured already. I can certify it as working since I'm actually using it in our prototypes... for your use I will provide a simplified version since there are a number of features that are useless.
I…"
the board I designed has been manifactured already. I can certify it as working since I'm actually using it in our prototypes... for your use I will provide a simplified version since there are a number of features that are useless.
I…"
"Hallo,I will send you my files ASAP (I got files @ my office and I'm out forholidays right now) .There are many free pcb design software, KiCAD is my favored but manyothers have nicer features. For 'compatibility' with my own work I wouldsuggest you…"
"Hallo,
of course yes. What files you need? Gerber or project ones?
Best Regards,
Mike"
of course yes. What files you need? Gerber or project ones?
Best Regards,
Mike"
"Hallo Divya,
what do you mean with .. "I'm not able to find any connector for 60 pin..." you mean that you're unable to identify the product or to find a reseller?
Anyway the connector part I'm using (and that you can use as well) is a…"
what do you mean with .. "I'm not able to find any connector for 60 pin..." you mean that you're unable to identify the product or to find a reseller?
Anyway the connector part I'm using (and that you can use as well) is a…"
"Hallo I'm currently designing a board that fits a microhard n920 radio unit (just the nano unit neither the ip rev nor the full dev board) into a very small board with a level translator. If you still need it I can send you the project (i mean…"
