Hi
I am using a 3 servo 120 degree swashplate configuration, I am using a 50 mm servo linkage arm for each servo. I wanted to know if there is a calculation method to find the required change in angle of the servo for specific blade angles. Ie: for a
Read more…Hi
I am new to coding and I am trying to control ESCs through a PS3 controller which will be coded on the Raspberry Pi B+. I think this can be done, but i have read in a lot of places that I need to use an additional board? Is this the case?
I have fou
Read more…Hi
I am building a micro uav. I was hoping there there would be VTOL. For this it would begin in helicopter mode, and ascend to a specific altitude, and then there would be a transition phase. Where the motors on the side would tilt from vertical posi
Read more…