Using APM Planner and F450 with Pixhawk running 3.2.1. After a successful flight, cannot disarm the Pixhawk using the transmitter sticks. I have to disarm using APM Planner. I am also having trouble arming the Pixhawk using the transmitter.
Why would
Read more…Have been using v3.2.1 for a couple of weeks and after every couple of flights the settings I have in APM Planner for stabilizing the servo gimbal are lost. In flight I realize it is not steady and have to go back into APM planner and re-enter the se
Read more…I am having huge problems with magnetic interference when I fly my quad. I had recalibrated the compass dozens of times, replaced the gps/compass, raised the gps as high as the wire will allow (10cm). I even moved the battery and power wires under
Read more…So I am at the end of my rope. I cannot get my quad to be even the most basic stabilized. In no wind it drifts all over roll, pitch, yaw. I have calibrated the compass, accelerometer, radio…everything. Ran compass mot several times to make sure in
Read more…I have been flying with a Bilxer 1.1 and APM 2.5 for several months with few problems. I upgraded the motor/ESC and then balanced and recalibrated the accelerometer. Now when sitting still on the ground the plane is reporting that is it bouncing, t
Read more…I have a low end MD80 camera on my Bixler1.1 which takes decent video footage. But when I turn on the autopilot into FBWA mode the video has waves in it. The plane is steady, flies like a dream with the autopilot but the video is distorted. When I
Read more…Rookie here. Got my receiver all setup and connect to ESC, binded transmitter fine. Tested all servos, worked great. Plug in the battery the thirty time and now when I push the throttle the main motor doesn't fire up, it spins slowly, making a pain
Read more…