About

Gender

Male


Location

Sebastopol, CA


About Me:

long time R/C enthusiast with an attraction to microprocessors, sensors, and other electronics


Please tell us a bit about your UAV interest

present interest is in autonomous landing of planes onto hard surface runway.


Activity Feed

Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"Thank you to Carmen and 3DR support team for posting firmware, and equally importantly, a .pdf with instructions on setting up the DIY drones version of the remzibi OSD board  (along with the differences between the DIY board and the original…"
Mar 23, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"Patience prevails (thanks to Paul and his detailed blog http://www.happykillmore.com/Software/Faq.asp#2 )
 The DIY remzibi OSD board only powers up when you provide the +12V and GND to (the 2 pins near the top of the image above).   To put the board…"
Mar 16, 2012
Tom Low left a comment for Rod
"Hi there Rod.    You commented that you got the DIY rembzibi OSD to work.  I still get "Failed: OSD did not respond" error when I try <Start Test> in the Serial Cable Setup tab.   (I am using the DIY drones FTDI cable connecting to (TX,RX,5V,GND) on…"
Mar 16, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"installed remzibi OSD on Vista x64.  Tried to do Serial Setup without success.  Used DIY drones FTDI cable to connect to DIY drones board (no other pins connected to anything), performed connect to COM23, then (per instructions) hold down SW1 while…"
Mar 15, 2012
Tom Low commented on Sam Kelly's blog post Remzibi OSD now in stock at the DIY Drones store
"I'm sorry I didn't read these posts more carefully before I spent >$110 w tax and shipping for this seemingly undocumented offering from 3D Robotics.   After spending most of the day trying to figure out the pin assignments and map them onto the…"
Mar 11, 2012