Watit K's Discussions

Watit K's Discussions (2)

Sort by

after install Firmware onto Pixhawk, the propellor doesn't move

Dear all,

I use "Skywalker" using Pixhawk. At first, when I turn the throtle up, the propellor can drive. But after I did following these;

- Loading firmware ( i plug in all cables into Pixhawk at this step ) http://planner.ardupilot.com/wiki/common-

Can't start the engine after install Firmware onto Pixhawk

Dear all,

I am very new for flying model "Skywalker" using Pixhawk. At first, when I turn the throtle up, the propellor can drive. But after I did following these;

- Loading firmware ( i plug in all cables into Pixhawk at this step ) http://planner.a

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

after install Firmware onto Pixhawk, the propellor doesn't move

Can't start the engine after install Firmware onto Pixhawk

Note: this page contains paid content.