3D-printed holder for Taranis flight mode switch

This is the first version of my mode switch holder for the Taranis. It fits the Hobbyking / X-Rock mode switch. It mounts in place of the left slider (I pretty much never use the sliders). A hole to route the cables is included in the design. This version still is a little bit close to switch E. Still doing some fine tuning.

Published under CC-BY-SA 3.0
Download at http://stefan.gofferje.net/downloads/file/31-taranis-mode-switch-ho...

Views: 692


MR60
Comment by Hugues on December 18, 2016 at 12:50am

nice

Comment by Marc Dornan on December 19, 2016 at 8:28am

Another option, and I prefer the ergonomics, is to use a Tarot Monitor Bracket ($8 on eBay).

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service