8-3-12 Balloon/Glider Flight

It flew ! For 50 feet off ground. Premature rope cut ! Dang....getting closer

3689471659?profile=original

Moment of ground release.

3689471571?profile=original

Next Friday...8-10-12...same time ...same place...another launch !

Earl

E-mail me when people leave their comments –

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • More Pics..

    Earl

    3692482540?profile=original3692482658?profile=original3692482642?profile=original3692482571?profile=original3692482706?profile=original

  • Arduino cut down CPU reset several times. I am triggering the hex-fet cut down nichrome wire off the red led d13 on the FIO Arduino. When it resets, the red led flashes 3 times then goes into the timer mode. During the 3 flashes, it is heating the wire. Continuous resets, flashing of the led, heat the wire enough to melt the rope.

    Next flight, we trigger the hex-fet from another digital output like D12 that does not go high during reset.

    That's my story.....and I'm stickin to it !

    Earl

  • hope next friday goes good.

  • Keep up the good work... one step at a time, regardless of how small each step is.  ;-)  Like Monroe, I'd be interested in hearing the results of a root cause analysis. 

    Good luck next week!

  • Congrats Earl! :)

This reply was deleted.