Views: 783


3D Robotics
Comment by Chris Anderson on March 29, 2018 at 8:53am

Is this a clone of the Sprite?

Comment by QuadrotorThai Tevada on March 30, 2018 at 6:12am

How to make it?

Comment by Jiaqi Hu on July 2, 2018 at 3:22am

Chris,

This project is not directly related to Sprite. When I was researching and developing this project, Sprite did not receive crowdfunding. There is also little public information. So I can't reverse engineer the design of Sprite. Many of our design ideas are similar, but not identical. In the future, I will open source my hardware design, and I hope others can share  the innovations that have been completed on the basis of my design, which will benefit more people. 

Comment by Jiaqi Hu on July 2, 2018 at 3:23am

this vehicle used two modified 1806 brushless motors as the power, two servos used to control the swashplate, yaw use differential control.

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service