Blogs

Indoor Flying Robot (Quadrotor) update

Posted by Michael Vowles on September 11, 2010 at 5:00pm

3689370128?profile=original

Thought I would share the progress on our quadrotor, we have done the PID tuning but have noticed in the test rig that it tends to 'rock' to the same side in both pitching and rolling from a straight and level position. We think we can put this down to the way the quad sits in the test rig. Next we look at doing a flight test once we receive our new engine mounts.


For those interested ther engine mounts and baseplate were constructed using a rapid prototyper and are made out of ABS plastic which is quite strong.


Cheers,



E-mail me when people leave their comments –
Follow

You need to be a member of diydrones to add comments!

Join diydrones

Comments

  • Chris Walsh September 13, 2010 at 11:05pm
    We aren't locking the mounts on yet as we want the flexibility to shift them in and out.

    RP the components was possible due to manipulating the university's resources to our advantage ;)

    I would have to agree with the prop tips, wouldn't a more vivid colour do a better job?
  • AVS September 12, 2010 at 7:43am
    Great setup. I did the same but only a small hand slice! Copters are very dangerous, escpecially in the early days of trying your own code mods. I learnt the lesson of "props always off" until proven but you 10kg weight is another alternative :)
  • Michael Vowles September 12, 2010 at 3:59am
    Ha, Not quite those weights are there for a good reason as we had the thing lift off the table in the test rig when one of the team members was messing around with the serial commands and ended up slicing his hand quite badly.
This reply was deleted.