Getting down to target weight has been challenging.

This version is lighter, stronger, and stiffer than its predecessors. Only airtime and hard landings will show if its good enough.

I'm printing in PLA with 60% infill, 0.2mm layers and slow print speeds which seems to give the strongest parts.

I'll post photos when its assembled.

Views: 407

Comment

You need to be a member of DIY Drones to add comments!

Join DIY Drones

Groups

Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2018   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service