Coming from a JP Zagi I wanted dual channel ailerons (achieved via elevons) but I wanted to still be able to remove my wings easily. Having seen lots of aileron mods I decided I knew where the leads would come out on mine and began my grooving. Grooved for the wires soon revealed the connector to be 3x thicker than the wire so a bigger groove was fashioned for the side for a snug fit. Now although pushing in a connector meant it did not move (snug groove cutting) pulling the connector out meant it pulled out a bit. CA glue to the rescue.
You need to be a member of diydrones to add comments!
Comments