Discussions

I am new to quadcopter and RC world.

I buy from ebay my kit and built my quadcopter assembling all the parts following various instructions from various websites.

I buy this kit to build for my son and up to date I have not see the quadcopter running.

This is a DIY HJ-F450 Quadcopter kit, it was unassembled with the following specification

Package Includes: 
1 x F450 frame kit
4 x F450/F550 Landing gear
4 x DJI 2212 920KV Brushless motor
4 x HP Simonk 30A Speed Controller
1 x APM2.8 Flight controller
1 x NEO-7M GPS
1 x Gemfan 1045(CW+CCW) Black Propeller
1 x Gemfan 1045(CW+CCW) Orange Propeller
1 x GPS Bracket

I use a 2700mah  3S Lipo battery and a 6CH FUTABA radio system T8J.

It uses ARDUCOPTER APM 2.8 with compass.

I have connect all the ESC with the motors and I cannot see all 4 motors running in ESC calibration mode through the mission planner.

1. I used wizard given in Mission Planner.
2. My doubt is how to calibrate and how to setup the RC control with the ARDUCOPTER.
3. I am trying to set up from Mission planner but i get confused

Any idea what could go worng? or board is faulty?

Thanks in advance for your help.

1.jpg

2.jpg

3.jpg