I have a Pixhawk with ArduPlane 3.2.3 on it that crashed. This combination of parameters and firmware has several hundred hours on it and in air crashes are rare ( sadly bad launches and landings are more common than I would like but they are user er
Read more…I have a pixhawk and it uses PPM so I cant just switch the wires from the receiver to the auto pilot and the dx6i cant re map the channels as far as I can tell.
currently the input channels are mapped as follows
transmitter > autopilot
throttle > ailer
Read more…I have noticed that sometimes mission planner assumes that I am using a copter when it is not connected to my plane.
The little icon for the vehicle in the flight data tab briefly switches to a quad copter (before disappearing) and then there is no f
Read more…Data flash says this:
FMT, 13, 51, TECS, ffffffffffff, h,dh,h_dem,dh_dem,sp_dem,sp,dsp,ith,iph,th,ph,dsp_dem
I have no idea what most of those values mean and I cant find anything other than the arducopter data flash message explanation.
Read more…I switched from V2.73 to 2.74b and in doing so, the LOG_BITMASK changed from 5 (fast attitude and GPS) to 69 (fast attitude, GPS and MODE) without me noticing. long story short i did a few flights and it appears that neither the tlog or the onboard l
Read more…