Gender
Male
About
Please tell us a bit about your UAV interest
PIXHAWK, PX4
Hometown:
Sydney, Australia
Activity Feed
"My /etc/config.txt file:
# Generic Quadcopter xset VEHICLE_TYPE mcset MIXER FMU_quad_x# PX4IO PWM output will be used by default
set PWM_OUTPUTS 1234 # Change parameters for the first 4 outputsset PWM_RATE 400 # Set PWM rate to 400 Hz for better…"
# Generic Quadcopter xset VEHICLE_TYPE mcset MIXER FMU_quad_x# PX4IO PWM output will be used by default
set PWM_OUTPUTS 1234 # Change parameters for the first 4 outputsset PWM_RATE 400 # Set PWM rate to 400 Hz for better…"
"No sorry, you don't need the rc.txt anymore, the autoconfig will do most of that for you. Just config.txt will be fine.
I don't have the PX4 with me ATM, will upload my config.txt later."
I don't have the PX4 with me ATM, will upload my config.txt later."
"1, 4001 or 4011
2, yes, that what I have done."
2, yes, that what I have done."
"Found out what was the problem, for someone who might experiencing the same issue, it was because the airframe model was selected wrong, and the /etc/rc.txt, /etc/config.txt files not created on the SD card."
Hi Guys,I am using the PX4 FMU V1.7.2 with IO V1.3.1, QGC 2.0.3beta, the latest QGC firmware, Quad with 4 x 40A SimonK firmware ESCs and 2815-470KV motors.The installation/setup was straight forward, the firmware was updated smoothly, the RC and…
