"I dont but i was thinking about going down the route of a local club.
I am using a power module and have removed the jp1.
I am wondering if issue could be with the order I power up the quad and tx or that I am not using a ppm signal set up ... This…"
"A couple of other things that were puzzling me:
-Do I need to provide an additional power source to the receiver ... currently I am using a 3-cable via channel 5 on the APM to channel 5 on the receiver to power it only. It does light up.
-Once it is…"
I am using the turnigy 9x8c-v2 receiver. I have now seen that the transmitter has an option to select between PPM and PMC (?). I have been following the wiki, it has been useful so far.
"Hi martin,
Yes I did bind it ... The red light stopped flashing on the receiver. The trouble is I have read too much on forums and the internet it is now confusing me. I'm not sure is the Turnigy 9x is 'PPM' so where I should have all the signals…"
Hi,I am working on this for a school project. I have a APM 2.6 with a turnigy 9x transmitter and standard reciever out of the box. I have wired it all together as I think I should ... loaded up the mission control and when I calibrate the…