Gender
Male
About
Location
Matawan, NJ
About Me:
Programmer and woodworker.
Please tell us a bit about your UAV interest
I've always wanted an RC helicopter. I've messed around with Arduinos in the past and stumbled upon this site.
Hometown:
Brooklyn NY
Activity Feed
Soldered up my new PDB yesterday. Connected everything today and went through the configuration steps in the instructions. Got to the part where I go into CLI mode, type "setup" then "motors" then connected my main power and poof. I got…
Hi, I'm a complete newb; this is my first RC project. I'm building a quadcopter with an APM2. I have the whole thing assembled and am going through the initial configuration checklist. I got up to the point of rotor direction and set the spin…
"I'll be following your thread; I have the same frame. This will be my first copter and would be interested in your PID settings once it get it all worked out. Have all the parts I need except the APM2. "
