Gender
Male
About
Location
Devon
Please tell us a bit about your UAV interest
Extreme Newbie :D
Hometown:
Ilfracombe
Activity Feed
Hi All,Have just finished my new 3D printed quadcopter build using a Pixhawk controller, Q-Brain 25amp ESC and 4 800KV motors spinning 10 inch props.Having a couple of small issues which i'm struggling to find relevant information on.The first issue…
"Just to keep this up to date in case someone has the same issues.
My power module is outputting just under 9volts!! So looks like a faulty power module is the cause of the issue with the pixhawk turning off. New power module ordered.
The ESC I…"
My power module is outputting just under 9volts!! So looks like a faulty power module is the cause of the issue with the pixhawk turning off. New power module ordered.
The ESC I…"
"Ok, After a night of experimenting I have discovered it is something to do with the ESC.
I plugged in a single ESC I had with a ducted fan attached and that worked fine.
The ESC I have is this…"
I plugged in a single ESC I had with a ducted fan attached and that worked fine.
The ESC I have is this…"
Hi all,I have recently decided to build myself a quadcopter and after lots of reading I went for a pixhawk board (I think it's a clone though as it was ordered from goodlucksell on ebay).I started by just connecting the pixhawk to the PC via USB and…
