Gender
Male
About
Please tell us a bit about your UAV interest
Quads
Hometown:
Burgas
Activity Feed
"210$ for 10000 mah batttery/ No thank you!"
"I havent. And i dont think i have mentioned what ESC im using :) Im using 20A esc. I guess i will just order new power module and wait for it. Harry Courter said:
Well a bad power module is better than voltage lag creating your problem.
Have you…"
Well a bad power module is better than voltage lag creating your problem.
Have you…"
"Thats is true and also not true. True that the current never stops changing. Also true that the voltage drops under load, BUT when it drops, its constant in the range of 0.2 Volts and it does not change every second. In my case the voltage is all…"
"If you do so, pls post the results. TechSully said:
I have a new build that this is happening too (voltage fluctuating 1.5 to 2 volts)... my 4 other quads do not fluctuate as much as the new build is doing, so I am inclined to think the power…"
I have a new build that this is happening too (voltage fluctuating 1.5 to 2 volts)... my 4 other quads do not fluctuate as much as the new build is doing, so I am inclined to think the power…"
"I have rctimer 5010 motors with 17 inch propellers, 10000 mah 3s battery. The current is 11 A at hover and 15A at flight. Im uploading the graph of the battery voltageUntitled.png"
"I tested it with 2 batteries. I have battery monitor connected on the side and its stable. Can it be bad power module? Diven Parker said:
You can change another 3S Lipo battery and test if everything goes well, if the voltage still going up and…"
You can change another 3S Lipo battery and test if everything goes well, if the voltage still going up and…"
"How many users does this forum has? This is the third time i post a topic with 0 reply. Letter from a dead man..."
I have the power module, but the voltage of the battery keeps going up and down non stop. Every second its different. One second 11 volts, the other 10.6, the other 11.1 and so on. My quad did 2 landings because of low battery when i have set it to…
Hello, Iv just built my pixhawk quadcopter but I have problems with the neo 6m gps. I get 6 sats 3d fix for about 5 seconds, then 0 sats for about 5 seconds and this repeats forever. Are there any params I can tweak or its a fault gps unit? I have…
My APM 2.8 flight controller stopped responding.I dont remember should the PC make a sound when i connect the APM to the PC, but there is no sound. There is just one orange stable light and thats it, no blue, no red. Not reponding on batter and USB…
"Im using FrSky d8r-II Plus, binded to the radio. I took it off my other quadcopter. I did the RC calibration in the APM and its working so its not from the radio. I also tested the motors and esc, one by one, on my old setup and they are workingIm…"
Hello,i have issues calibrating/using OPTO ESCs with APM 2.6. No matter what i do i cant calibrate or make them work, using either all at once or one by one method. There are only black and white wire on the ESC. Im using APM power module. There is…
