Taz85268's Discussions

Taz85268's Discussions (4)

Sort by

Pixhawk Gimbal Control on AC3.3

I would like to control my Camera Gimbal in two modes.

Mode 1: Pixhawk controls ONLY Pitch and the Gimbal controller maintains level in the Roll axis for Standard Horizontal Flight Aerial Photography.

Mode 2: Pxhawk controls Pitch (as normal) but sends

Started by Taz85268

Mission Planner - DO_SET_ROI modification request

For all those developers out there for Mission Planner, i would like to make a request regarding the setting of DO_SET_ROI.

The default action of setting multiple WayPoints in Mission planner is for a multirotor to face the next Way-point.
I know that

Started by Taz85268

A4 Motor LED output

Hi All,

Is there a way to get the A4 Motor Led output to toggle depending upon a channel input (Say Channel 8) from the receiver in order to turn on my Nav LED's?

I plan on using a ULN2003 to drive the Nav LED's and was considering ripping out a Servo

Started by Taz85268

Facing a gps coordinate in way point editor

I was wondering if there was a facility in mission planner way point editor to face a specified GPS coordinate when my quad reached a way point and then I could trigger a camera shot.

Started by Taz85268

#xg { position:relative;top:120px; } #xn_bar { top:120px; }

Hello, you need to enable JavaScript to use diydrones.

Please check your browser settings or contact your system administrator.

Pixhawk Gimbal Control on AC3.3

Mission Planner - DO_SET_ROI modification request

A4 Motor LED output

Facing a gps coordinate in way point editor

Note: this page contains paid content.