ive been working on a tricopter for a few weeks in autodesk inventor and am wondering what power setup i should go with and if you guys think this thing will even fly. they are 90mm edf cowls and all three rotate like an osprey, the fuselage can hold up to a 6s lipo.
You need to be a member of diydrones to add comments!
Replies
thank you, this is how i was planning on printing it, and using carbon fiber rods to connect the wings and skids, and a carbon tube or something to hold the tail on. the tail was originally going to rotate as well but i realized its kind of redundant when i could use the front edfs for rudder.
if its printed with ABS plastic and full infill the total mass of just the 3d printed parts is 3.08 lbs. do you think thats too heavy?