Gender
Male
About
Location
West Sacramento, CA
About Me:
.
Please tell us a bit about your UAV interest
. .
Hometown:
West Sacramento
Activity Feed
so i got a 4in1 module from banggood and got it installed and working with my tiny whoop and proto-x. but im trying to get my diatone 150 with a lemon rx sat to bind, ive tried the "set spektrum_sat_bind=" in cleanflight with several different code…
"thank you, this is how i was planning on printing it, and using carbon fiber rods to connect the wings and skids, and a carbon tube or something to hold the tail on. the tail was originally going to rotate as well but i realized its kind of…"
"if its printed with ABS plastic and full infill the total mass of just the 3d printed parts is 3.08 lbs. do you think thats too heavy?"
ive been working on a tricopter for a few weeks in autodesk inventor and am wondering what power setup i should go with and if you guys think this thing will even fly. they are 90mm edf cowls and all three rotate like an osprey, the fuselage can…
