3D Robotics Quad with T8FG Super RC (Problems)

Hello All,

I recently received the above kit and RC. I've assembled everything and followed the mission planner steps up to spinning the motors to check direction. The motors will not spin. Unfortunately, I've performed calibration on both the RC and mission planner software. I'm not sure what to do next. I'm new to this world and any help / advice would be greatly appreciated. 

20131005_114400_resized.jpg

20131005_114408(0)_resized_1.jpg

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –

Replies

  • is your connections proper ??? 

    in this image i cant see clearly . but i thing you are using power distribution board . remove the esc wire and connect it directly to apm board to power it 

    regards,

    UNMANNED ENGINEERIA 

  • Did you calibrate the Speed controllers?

  • Just to be clear, The motors do not spin.

This reply was deleted.

Activity