Hi, need help of pairing the Pixhawk with Optima 9 receiver. Already success the  firmware upgrade (v3.01) via HP-22  for both receiver and 2.4 module as per the wiki below:


Also already done the binding procedure and add jumpers to CH 3&4, 6&7 while binding.

Q : Do i still need the PPM Encoder from Pixhawk to the Optima 9 receiver?

 If no. Where do I connect the RC out pins to the receiver? seems Optima doesnt have S-Bus port.

Views: 1053

Reply to This

Replies to This Discussion


Where you able to connect the Pixhawk with an Optima receiver?

Hi guys: I have an Aurora 9 and this what I do: I bought this cheap receivers from HK with PPM and connect there througth PPM http://www.hobbyking.com/hobbyking/store/__60516__2_4Ghz_A_FHSS_Com...   

Reply to Discussion



Season Two of the Trust Time Trial (T3) Contest 
A list of all T3 contests is here. The current round, the Vertical Horizontal one, is here

© 2019   Created by Chris Anderson.   Powered by

Badges  |  Report an Issue  |  Terms of Service