3DR Radio on APM2.5.2 Connect but having Terminal Problems

Hello Everyone

I have a 3dr radio telemetry v2 on APM2.5.2.

First i setup the board and test it with usb (no 3dr conncted) and worked perfect.

Then with the 3dr radio (no usb connected) i can connect with Mission Planner on 57600 baud rate.

Until here everything is normal.

When i try to check motors (ARM- DISARM) work fine and Arming the Board.

Here is the strange thing

When i try to adjust the throtlle the motors doen't spin.

Then the other strange thing

I go to Terminal and try to open com port and after that when i push connect , the terminal printing non recognizable characters (like chinese!!!!).

So is there any changes that required on APM or the 3dr radio?

Marcin Krawczyk April 17, 2014 at 11:39pm

AFAIK connecting to CLI over telemetry is only possible for the first 20 seconds after power to APM has been connected.

Later you will see MAVlink binary messages...
- Mike > Marcin Krawczyk April 18, 2014 at 2:59pm
  
  Thanks, it's now working.
Mike April 17, 2014 at 1:58pm

Hi,

Did you find a solution to this problem? I have just installed 3DR radio and found the same issue.
Hercules March 7, 2014 at 1:16pm

Anyone to reply????

This reply was deleted.

Discussions