Gender
Male
About
Please tell us a bit about your UAV interest
I am an amateur uav designer
Hometown:
Greece
Activity Feed
"Anyone to reply????"
Hello EveryoneI have a 3dr radio telemetry v2 on APM2.5.2.First i setup the board and test it with usb (no 3dr conncted) and worked perfect.Then with the 3dr radio (no usb connected) i can connect with Mission Planner on 57600 baud rate.Until here…
"And me too on apm2.5.2 , any solution?"
"Hi Robert again
Another thing that is mystery is that i try to load previous versions of aducopter but from those versions that i download from the web i cannot load version previous of 3.x. Then i try to load the default arduplane v2.78 from MP and…"
Another thing that is mystery is that i try to load previous versions of aducopter but from those versions that i download from the web i cannot load version previous of 3.x. Then i try to load the default arduplane v2.78 from MP and…"
"Hi, Robert,
I check everything and i am sure that from my source code the sr3 and sr2 settings are missing. I think that the telemetry port use these settings. When i try to connect with 3dr's i see the blinkink leds on both radios BUT the ground…"
I check everything and i am sure that from my source code the sr3 and sr2 settings are missing. I think that the telemetry port use these settings. When i try to connect with 3dr's i see the blinkink leds on both radios BUT the ground…"
"Thank you for your reply Robert
My problem is that (i think) my radios paired up as the green LED on both radios is solid green. But when i try to connect with MP nothing happen (No Heartbeat packet receive fter timeout). First i check the drivers ,…"
My problem is that (i think) my radios paired up as the green LED on both radios is solid green. But when i try to connect with MP nothing happen (No Heartbeat packet receive fter timeout). First i check the drivers ,…"
Hello everyoneI setup my quadcopter recently. My board is apm2.5 and for telemetry i use 3dr 900 radios v.2. I load the arducopter v3.1.1 firmware on apm and with usb cable i can connect perfectly. But when i try via 3dr no connection at all. I am…
Hello , Please Help!!!!!!!!!!I am trying to connect xbee xb24 with mission planner. I succesfully configure the two radios via xctu soft , and the two radios are communicate perfectly. After that i open the mission planner and check that i have the…
