Hello all ,
I just get Digi 9xTend 900 Mhz and I want to connect it to my pixhack ( chines pixhawk )
I can't configure the 9xTend and connect it to the XCTU software using TTL ,
the pin out of the 9xTend is :
pin 1= GND
pin 2 = VCC
pin 3 = GP02/RX LED
pin 4 = TX_PWR
pin 5 = DI ( Data In )
pin 6 = DO ( Data Out )
pin 7 = SHDN
pin 8 = GPI2/Sleep
pin 9 = GPO1/CTS/RS-485 TX_EN
pin 10 = GPI1/RTS/CMD
pin 11 = CONFIG/RSSI
others pin are reversed
my connection is like
TTL ----> 9xtend
----------------------------
GND ---> GND
VCC ---> VCC
TX -----> DI (DATA IN)
RX -----> DO (DATA OUT)
I am not sure about the other pins
I connected others as
TTL -------> 9xTend
CTS ---> Pin 9 GPO1/CTS/RS-485 TX_EN
DTR ---> Pin 10 GPI1/RTS/CMD
after connect to my pc and open the XCTU software and try to connect with baud rate = 9600 and 57600 and all can't connect I get this msg
Hope I can find help in how to connect it with my computer ,
Best regards ,.
Replies