Discussions

After update to 3.1

Posted by George van Eerden on January 5, 2014 at 1:46pm

Just updated to 3.1 on my hexa .and am wondering if I should go through complete setup, like radio,ESC calibration, say starting from beginning or just do the things mentioned in the release. Reason I'm asking is I'm unclear on what all gets changed. I've read as much as I can find .Not sure if all info is always put in the wiki or if some is assumed that I should know. 

Another question is EEPROM, do I need to do anything there,maybe a dumb question but I read something somewhere(can't find it again).

BTW I did check for 3.3V and that's what I have after update,so that's good.

You need to be a member of diydrones to add comments!

Join diydrones

Email me when people reply –
Follow

Replies

  • T3
    Richard Boyhan January 5, 2014 at 4:55pm
    A lot depends on what version you are coming from. But doing a clean setup never hurts. Just remember to save your parameter and do a compare to reload only those parameters you want to keep, like flight modes. Good luck and fly safe.
This reply was deleted.

Activity