Hi All,Since updating to the latest code i cant seem to get airspeed to show up in the MAVLINK GCS in the Planner, when using Xbee...
If i go to CLI, and test the airspeed sensor, it works.
If i power the APM with usb, Airspeed works over XBEE in Planner's MAVLINK GCS
If i power APM with only a BEC supplying 5V, everything in Planner's MAVLINK GCS works, except for airspeed
I have also tested a couple BEC's to make sure its not that.
The strange thing is that I have two new APMs. Both the controller board and the oilpan. The same happens for both of them... Has anyone else seen behavior similar to this?
Regards,
Willem
Replies