I currently have an apm2 with jumper installed for power. Plugging in camera servos per wiki causes esc to not start up and there is no servo movement or power. What is the correct setup to get these servos to work?
You need to be a member of diydrones to add comments!
Replies
Please check if you are connecting the servos to the A10 and A11 pins. In the wiki photos the A10 and A11 are the last installed pins before the memory card but between them and the card they are two rows of three empty holes. My APM2 board came with those pins populated so if you don't care this you can plug the servos in the wrong leads.
Hope this helps.